Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It's been several years since I set up non-DMVPN IPSEC VPNs. At the time it was Pix 515s. If I remember correctly, I could set up either a site-to-site vpn (in which phase I and phase II specs were entered, PSK, etc.) of a remote-user vpn (whe...
It's been several years since I set up non-DMVPN IPSEC VPNs. At the time it was Pix 515s. If I remember correctly, I could set up either a site-to-site vpn (in which phase I and phase II specs were entered, PSK, etc.) of a remote-user vpn (where t...
I'm running version 4.1.6 of Cisco Clean Access and would like to create a Requirement that a good AS package is installedd and running. But I see that there aren't all that many to choose from in CCA. The favorite around here is Malwarebytes. How ...
Perplexed by something . I'm trying to clean up some 2950 L2 switch configs. On all switches, a predecessor configured snmp and syslog logging, but the configs reference a non-existent server IP address. That's fine - I can just change the address...
On a 4506 L3 switch, a predecessor configured 'no ip route-cache cef' on the vlan SVIs. I would like to re-enable cef, but am not sure if it is actually disabled on these interfaces. 'Sh int switching' seems to confirm the configuration by showing ...
You are correct, sir. BeeVPN supports DTLS/SSL (AnyConnect) vpns. In fact, I currently have AnyConnect set up on an ASA here. But the reason he wants to terminate the vpn on a router/firewall is that he wants only MOST of his traffic insulated by ...
Even with a misconfigured smmp on the remote switch, snmp GET requests are unicast from the NMS to the remote switch with a dest port of udp 161; GET responses are unicast from the remote switch back to the NMS with a source port of udp 161. Can w...
