Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys i need some help pleaseI was asked to observe the following information on two core routers (CISCO 3560G-48TS-E, each router is connected to 3 remote routers)and prepare an analyze report based on:- Lost packets- Dropped Packets- CPU load- A...
Hi mates,I have 2 cisco switches (switch A and switch B) connected each other.CiscoView allow me to see switch A when i type switch A's IP addresssame way i can see the Switch Bbut I want to see both switches at the same time, is that possible, if po...
I have installed common services without any problem, when I begin to install RME, I get error message. I captured the screen, please see the attached file to see error message. (can not stop crmdmgtd)After this error, I ve stopped the LMS deamon ser...
Hi guys I have configured and delivered to customer a network system consists of five 4506 switches (with 24 port MTRJ fiber optic line card and gigabit fiber LC SFPmodule).Customer is asking me protective maintenance documentation for 4506 switches...
hi Can anyone give me a hand pls? here is the situation:- LMS 2.5.1 on Win 2003 Server R2- License file sent from CISCO was put in the LMSLicense directory and successfully located during RME Installation. when I try to open licensing;common service...
thanks a lot!i think whatever GUI i use(like LMS), they won't get me anythink more than i can get from CLI right? bcs i have only one day on site and have no time to learn using that program. i am familiar with CLI so i prefer to use commands you ga...
Hi Wilson Tx a lot for your helpful inforrmation. Does sh interface comman shows the packet lost?bad point is ı've got only one day in the site (where the routers are) and i dont have time learn using LMS kind of programs.CLI commands would be much...
tx jclarke, tx for replydo you mean I should open 2 Internet explorer and 2 times login as admin and open CiscoView on both Internet Explorer I've opened?when I have a network with lets say 10 switches and 10 routers, then I need to open 20 browsers ...
hi jclarkebrand new installation, changed values for TEMP and TMP under the C:\TEMPstill does not worksame error messages.(I sent on my previous posts)It makes no sense. clear installation, everything is in order and license server doesnt work.I ve o...
