Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a few ASR-920-24SZ which I'm testing. All ports light up yellow. When plugging in a GLC-SX-MM or GLC-SX-MMD the it gets detected in the CLI. But I'm not getting any green uplink. (all SFPs and fiber cable is working tested in many other cisco ...
Hello, I have about 11 of this swtich which are broken in different ways im gonna try to fix. And I'm gonna describe some of the problems I have found out. Switch 1: Green light from PSU LED 1 and or 2. FAN LED 1 and 2 are green. Front panel LED is O...
Hello! I also have this issue with a ASR1001-XI have uplink but I get output errors.Have tried unplugging SFP, restart but same issue remains.Tried different SFP's as well. Any other ideas we can try? #sh int gi0/0/2
GigabitEthernet0/0/2 is up, line ...
Did you try my steps with Tera Term? For me it works much better than pressing Ctrl + F. Plug in Cisco orginal serial cable Wait for this message *** The system will autoboot in 5 seconds *** In TeraTerm, press Control > Send Break
Plug in Cisco orginal serial cable Wait for this message *** The system will autoboot in 5 seconds *** In TeraTerm, press Control > Send Break flash_init:dir flash:delete flash:config.textchoose yesdelete flash:private-configchoose yes then if you ha...
I had this problem, I send brake command didn't work on any of these 20 ME switches I had. Tested different terminals (Putty, Tera Term, MInicom). But I found out that the problem was my serial cable. I changed to a Cisco orginal blue serial cable an...
Hello sir!No it wasn't possible to do it. It said it's already initizalied if I remember correct.And I also could not doswitch:bootit didn't find any cisco image. But now I restarted the switch again and now it started to load into the Cisco image th...
