Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi the community, Using Wireshark in area 0 ABR router, I have seen LSU packet received concerning static network redistributed to OSPF area x on one ASBR router. Is there a reason to have LSU packet received and received again for a static route re...
Hello,I have a Cisco Router ASR1001-X IOS 16.06.07 connected to a switch using SFP module and copper cable.All was fine but 3 days ago during a check task I have seen that the routeur doesn't respond to ping on the IP address configured on this inter...
Hi the Community, On an ISR4331 or ASR 1001-x routers:If there are multiple way to join a network with OSPF routing protocol, is there a command to display all the way to join this specific network with the corresponding metric to understand why the ...
Hi the Community,I still have the same problem and would need your help. As you can see on the attached chart. I would like to force the route choice from the blue network to the green network to use "Site main router". Sometime on my production netw...
Hi the community,I have 2 ASR1001-X withe the same IOS version and the two havecrypto pki trustpoint TP-self-signed-XXXXXXX....andcrypto pki certificate chain TP-self-signed-XXXX. When I do a sh run on the first-one I can see the crypto pki certifica...
Hello BB,I don't have access to the router config but I have asked a copy and I'll post it as soon as possible. I think that maybe the router send LSU for statics routes every 30 minutes and I have recorded this packet. Do yo think that the router th...
Hello Community,I have power off the router, replaced the SFP module then power on the router and all works fine from now.Many thhanks for your help.Regards.
Hello Paul,Thanks for your help.I have already tested default interface, and creat a sub-interface. It didn't solve the problem.I'm not near the router but in couple of days I'll try to change the SFP module.The Output errors on the interface is stra...
Hello,The router is connected to à Dell S3048 switch.I have a case openned with Dell technical support. They have approuved the switch configuration.I think that the problems comes from the router because of 569 output errors on the interface that I...
