Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ASA SW version: 8.4(1)We disabled all portal layout (title panel,toolbar,navigation panel,custom panes and home page). Only the following is configured: @custom/applications rdp is checked @homepage bookmarks mode 'do not group' is chosen.The vis...
I'm struggling with the documentation.More exactly with layer 1.Material: c1841 with HWIC-4HSDSL.A cable is delivered from RJ45 to 2x RJ11In the documentation I find for the cabling:2wire, 4 wire and 8 wire + some cabling schemes. Eg(http://ciscosyst...
I've changed the password according to the procedure.Now after a reboot I can't login:localhost login:Login incorrectI tried admin/adminroot/ciscoroot/configured pwdnothing works!I can't access the server via web (license key need to be installed but...
I wondering which vlans need to be allowed over the trunk.Management vlanVlan towards internet...I'm wondering via which vlan the EoIP tunnel is setted up?I also suppose for AP-manager, I can use a useless random IP?
if you have two different dialer interfaceswith each a dialer-list permit ip any.Is the presence of ip traffic enough to activate an interface? or does it need to pass through the dialer interface.For example:ip route 0.0.0.0 0.0.0.0 Dialer1 ip route...
I was reading about ALB and had 3 small questionsquestion1------------------Cisco doc says:ALB does not take place if the threshold load-balancing window is not exceeded. That is, if the AP requested by the client is a valid candidate AP (current use...
So on one side I can use for examples pairs 0,1 and on the other side 2,3?What about 2,4,8 wires?For example 8 wires, in a phone cable? 2xRJ11 coupled?
Why 2 RJ11 connectors?So first I've to check how many wires my phone cable has?If for example my phone cable has 4 wires. dsl-group 0 pairs 0, 1ordsl-group 0 pairs 2,3If you have a clean installation then you can chose as long you use same pairs 0,...
