Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having around 50 cisco 2960 and 2960X switches. Every time I have to run the IP INT BRIEF | IN UP command on all switch to check the interface status. It is very hard to me login each and every device and run the command.Is their anything soluti...
I am having cisco switch at my HO (3850 switch) and DC end it is fortigate firewall Both the end having two ISP for redundancy purposeHO Side having two different router for different ISP and both link is terminated on cisco 3850 switch. 3850 I want ...
Device : SG300-28 28-Port Gigabit Managed SwitchSW version 1.4.11.5 ( date 08-Apr-2020 time 13:49:34 )Boot version 1.3.5.06 ( date 21-Jul-2013 time 15:12:10 )HW version V03 Switch port is getting UP/Down which connected to AP, I am confused that it ...
I have some point raised by audit team. I am having cisco 2811 router and recommanded below point to implement.Model : CISCO2811IOS : c2800nm-advsecurityk9-mz.124-20.T2.bin 'It is recommended to:- Disable SSLv2 and SSLv3- Use TLS 1.2 or 1.3 wi...
My all over country branch location connected to TATA MPLS but This particular branch (XYZ_Branch) location don't have TATA MPLS reachability at this area so we have decided to configure IPSEC tunnel between XYZ_Branch and TATA_MPLS. My local interne...
Ok, I will change the cable and check. Speed same at both side and showing : :full duplex and speed -1000" at both end as checked on both side interfaceSpeed :Auto Duplex : Auto
AP model :NAME: "AP1040", DESCR: "Cisco Aironet 1040 Series (IEEE 802.11n) Access Point" show spanning brief command is not supporting, Given output "show spanning-tree detail active" Switch#sh run int gi18interface gigabitethernet18description ***Up...
This is not an solution, It will erase all configuration, This can not say password recovery.I am facing same issue, Can I recover the password only withought erasing any config.
