Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a publisher installed, working fine and phones reg'd. On second ESX host, I try to install the Sub. When I get to the point where I enter the first nodes name, IP, and Sec code and select 'ok", I get the message " CUCM1 is not a first node". I...
On a six line 7960: Line1:9600 (shared line) Line2:9601 (shared line) Line3:9602 (shared line_ Line4: no ext Line5: no ext Line6:2000 (shared line)here goe...
If you followed the directions in the ASA quick start guide, there's your problem. The site to site instructions display a 'Tunnel Group Name' as "VPN group 1'. This would ONLY work if you use digital certificates on your network. Re-do the wizard on...
