Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,An Analog Phone with Display is connected to a VG224.When someone (external or internal) is calling the Analog Phone no Caller ID is visible on the Analog Phone.The VG224 has IOS 12.4.24T, CUCM Version 7.0.2VG224 ist configured as SCCP. Caller ...
Hello,a custumer want to change Softkeys in the Call State "Digits after firstON Hook". But this Call State ist Missing in CM6.1(2). "Digits after firstOFF Hook" exists. Is this normal ??Why can i use the "undefined key" in softkey template only once...
Hello,a customer has recorded a personal greeting. But when someone calls the extension he hears the personal greeting and the greeting from Unity : "leave your message after signal or wait for other options" , then the signal comes and you can leave...
Hello,we try to upgrade to CUCM 6.01 BE on a new Hardware. During the Installation of the BE there is no Option to Import Files from a previous CM Version.Is it possible to upgrade from CM4.x to CUCM 6.x BE ?????If its possible, how ???In the Install...
Hello,a costumer has an analog phone connected to an ata186.When he is calling out and the call lasts longer den 30Min , the call gets automaticaly disconnected.The IP-Phones work without problems.Is there a timer which disconnects calls after a peri...
Hi,you must set the following Parameter in the "Service Parameter" List to "true""Show Line Group Member DN in finalCalledPartyNumber CDR field"Regards Ralf
mmh.then i think only two options will be left.1. the configuration of the DP´s or the VG224 in CUCM are incorrect2. the IOS 15.1 of the VG224 is buggyregarding point 1 : I think you check the config and it is correct.regarding point 2 : try IOS 12.4...
Hi,ich checked your config with my own and i found 3 different commands i use.Perhaps this could solve the issue.1. i configured "ccm-manager sscp local FastEthernet0/0"2. if you want to use the supplementary features you must configure the command "...
Hi,are you sure the first 12 Ports of the VG224 register ? It should be in your case the last 12 + the 6 you configure for SRST mode.So together 18 Ports should be register in your case to the Voicegateway.You must configure all 24 ports of the VG224...
Hi,you must configure all ports of the VG224.Put those ports that you want to register in case of WAN failure in a device pool with SRST and the other in a Device pool with non SRST.But it is important that you configure all ports of the VG224 with a...
