Hi All I am struggling over 3 days to get Cisco Anyconnect profile working over Cisco FTD 5506-X HA firewalls. I am able to establish the Anyconnect session but can't reach IP address or services inside the corporate network.To rule out internal ro...
There are two nexus 7K switches in each datacentre connected via OTV. L2 port- channel is configured (consist with two 10G ports) between two DCs to support the OTV connectivity.
Port-channel load balance uses following mechanisms, but I can't see...
I am planing to upgrade the ISE appliances from 1.4 to 2.0.0.306, but I came across following issue with ISE version 2.0 patch one.
Please advise me about the fixed release?
Windows 10 devices can't connect to an 802.1X environment
http...
Windows 10 devices can't connect to an 802.1X environment (November Update)https://support.microsoft.com/en-gb/help/3121002/windows-10-devices-can-t-connect-to-an-802-1x-environmenthttps://support.microsoft.com/en-gb/help/3121002/windows-10-devices-c...
Please share your experiences, what is the best procedure to remove VPC configurations. Details as follows,
Platform - Nexus 7009
Firmware version - 6.2(16)
VPC - vpc domain configured on a specific VDC
I have followed the following procedure to ...
Hi RJII have done the NO NAT/ACCESS and Routing accordingly. I also verified many times.Please note attached Trace file as requested.10.2.254.142 is the GW to FW inside interface. Thank you for your quick response.
Hi Brumer
Configurations as follows,
interface Ethernet3/31 description Link between VDC's switchport switchport mode trunk switchport trunk allowed vlan 906 mtu 9216 channel-group 100 mode active no shutdown
interface Ethernet3/32 descr...
Hi Brandon
There are two port-channels, details as follows.
L3 PO (Same DC)- connects OTV VDC and Routed VDC - currently not load balancing.
L2 PO (between DCs) - connected routed VDCs between datacenters, I know this is confusing. This PO is on...
Hi Flavio Thank you for your response. I thought the same way and advised customer to make a cluster connection. I wanted verify my suggestion with other experts. thank you again