Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All I am struggling over 3 days to get Cisco Anyconnect profile working over Cisco FTD 5506-X HA firewalls. I am able to establish the Anyconnect session but can't reach IP address or services inside the corporate network.To rule out internal ro...
I am planing to upgrade the ISE appliances from 1.4 to 2.0.0.306, but I came across following issue with ISE version 2.0 patch one.
Please advise me about the fixed release?
Windows 10 devices can't connect to an 802.1X environment
http...
Windows 10 devices can't connect to an 802.1X environment (November Update)https://support.microsoft.com/en-gb/help/3121002/windows-10-devices-can-t-connect-to-an-802-1x-environmenthttps://support.microsoft.com/en-gb/help/3121002/windows-10-devices-c...
Please share your experiences, what is the best procedure to remove VPC configurations. Details as follows,
Platform - Nexus 7009
Firmware version - 6.2(16)
VPC - vpc domain configured on a specific VDC
I have followed the following procedure to ...
I am in a process of deploying ASA 5516x HA cluster ( Active/Standby), I need to connect this cluster to another FW HA cluster ( not sure about the vendor) with another organisation. I was given a network design physical connectivity as below, Cisc...
Hi RJII have done the NO NAT/ACCESS and Routing accordingly. I also verified many times.Please note attached Trace file as requested.10.2.254.142 is the GW to FW inside interface. Thank you for your quick response.
Hi Flavio Thank you for your response. I thought the same way and advised customer to make a cluster connection. I wanted verify my suggestion with other experts. thank you again
