Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have two 512 kbps of link from same ISP and both link were terminated on same router. I have different LAN/WAN pool for both ISP. M using nat on same router but want to do load sharing on both link.How it is possible. Pls help me out, Thanks ..
Hi,I have two 512 kbps of link from same ISP and both link were terminated on same router. I have different LAN/WAN pool for both ISP. M using nat on same router but want to do load sharing on both link.How it is possible.Pls help me out, Thanks ..
Dear All,from my vpn server side they have configured gw to gw VPN.So they have provide us following info.Stc peer address is abc.abc.abc.abcEncryption (3DES)Authentication pre-share key : *********Hash authentication (D5)Diffie-Hellman Group-1but w...
Hi Once the router is turned on,it tries to find the config file from the network.As there is no config on the router.So best solution is once you reach the router> prompt.You should use the command erase startup-config.After this configure the route...
Hi shahajiwe have to enable logging by giving logging buffered,this means we are configuring in the router to store the logging messages in RAM,so if you want to store cisco has provided an option to redirect the loggging messages to SYSLOG server.th...
HiIt supposed to be ethernet0 security level is 100,in PIX by default access is restricted from low security level(<100) to higher security level.so we have to explicitly grant the permission to acces from low security level to high security level
Hi, you can do this by going to the NetFlow collector and running NFUI on the flow collector.In there You define a thread in which you define the aggregation scheme and then you create a filter attached to it in which you can give the Particular pref...
