Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am removing a single switch from a LAN Automated stack of 3x switches but one of the fibre links is in the switch im trying to recover.I have been through the "delete link" process quite a few times so I am familar with it (aswell as the "add link"...
HiWe have a site which has multiple listed buildings and as such running copper/fibre between or installed p2p is a real headache. We are trying to cater for a CCTV system which will include many cameras connected across the site but will be connecte...
Hi I am trying to configure P2P Blocking Action to "drop" on our guest network but when trying to configure this it throws the following error (see below).Any suggestions?TIA
Hi allI am trying to replace a faulty 9300-24T with a new 9300-24T. I have following the "Replace a Faulty Device" section in the 2.2.3.6 user guide (Cisco DNA Center User Guide, Release 2.2.3 - Manage Your Inventory [Cisco DNA Center] - Cisco) but a...
Hi allCan anyone shed any light on why we would be seeing high ping loss (around 9%) on one specific SSID but other SSIDs are fine. Apart from the AAA settings all other settings are the same.When the ping drops, I can see in the mac address-table th...
I have accessed that function in 2 ways, 1 is to Provision -> LAN Automation -> LAN Automated Devices -> Delete Link..... and the other way is how you suggested, through Workflows -> Delete Link. Both ways I get the same issue.If I click on global an...
I think what you are suggesting is sending all traffic from building 2 (for eg.) back local to central hub and then back out the other spoke in building 1.We need local communication in case of ISP issues and local recording functionality.
The full mesh on site does sound good but not sure it would work for us.Here is a topology of what we have existing (hub and spoke - left) and the new site (right).All existing sites use AutoVPN to connect back to our central hub for DC connectivity....
Sorry to hijack this thread but it is the most relevant to my issue. I am experiencing the same issue but with a switch (not AP).How can I provision/assign a switch to a different site? When I go into the provision process the suit is greyed out. If ...
Thanks Marce1000, appreciate the info.I have had a read of that document and the restrictions only seem to apply to Flexconnect AP's, which we are not using. All our AP's centrally switch and are configured in local mode.I cannot seem to see anything...
