Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running the VPN client ver 4.7. Using the auto connect feature how can I get the client to auto connect no matter what IP address I get? I know how to do it for a specifice subnet, ex 192.168.x.x but what if I want to do for any IP address. Ca...
I have a laptop with a 2915ABG wireless card and am trying to connect to a Cisco access point using WPA-PSK. I have tried upgrading the drivers to the latest version but the laptop will never get an IP address. I have a Trend wireless router and thi...
I have a question about redundancy and HSRP. On switch A I have a trunk port set-up with VLAN 15-19 and on the MFSC I created VLAN 15- 19 and assigned IP addresses. We have Switch B connected to Switch A with a trunk port set-up between the two and w...
What is the best way to boot a CAT if you have bootflash and a PCMCIA card in the chassis?Is it boot from bootflash and then PCMCIA card if the image in bootflash is corrupt?Or is it boot from card and then bootflash if the image on the card is corru...
On one of our core siwtches that is running spanning tree I have noticed the following for the root for a spanning treeVLAN 47Spanning tree mode PVST+Spanning tree type ieeeSpanning tree enabledDesignated Root 00-00-00-0...
VLAN 47 has been cleared on the trunk on the core switch. I am assuming VLAN 47 is then still being passed by VTP and since VLAN 47 has been cleared off the trunk ports all of the access switches think they are the root switch for that VLAN. Makes it...
No on that switch there is no ports in that VLAN. What I find confusing is on our access switches the following shows up for that VLAN. All of the access switches have 2 GIG uplinks to the core switch.VLAN47 Spanning tree enabled protocol ieee Root...
