Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,I will need to stack a second C3750G-48TS to my setup.The instructions warn me to make sure that the power is switched off on the switch added to the stack.Does this also apply for the switch that I am stacking to?Or can I leave this one on?...
One of our 6509E VSS setups running SXI6 is experiencing high CPU load. It has just been upgraded from SXH5 and its CPU load has always been on the high side.But now it has become worse:CPU utilization for five seconds: 93%/19%; one minute: 92%; five...
Hello,I am trying to configure my 2 fxo ports on my 2811 router.The problem is that I can't acces the voice ports.The voice card is recognized by the system:2811CME#sh invNAME: "2811 chassis", DESCR: "2811 chassis"PID: CISCO2811 , VID: V05 , ...
I need to change two blades from my WS-6509-Es, which are configured in VSS and is in production.The blades that will replace the old blades are a different kind, I will exchange two WS-X6704-10GEs for two WS-X6748s.My question is: do I need to reloa...
Goodday,I have just installed a new 32 MB flash SIMM in my 2651 router.Router can't locate flash; it gives a bus error and a flash size is zero error.I loaded an IOS from TFTP with the tftpdnld -r command.Tried to find the flash but I can't:Router#sh...
Thank you for your support.Very helpfull comments and advice!It has been decided to the work in a maintenance window since the existing switches need IOS upgrades anyway.Willem
Thank you Dazhi Zhang,We have been monitoring as follows:monitor session 1 type local source cpu rp both destination interface gigabitethernet bla no shutdownIs this netdr the same thing?And what is impact on the cpu when we invoke netdr debugging?Ag...
Hello Rahul and Reza,Thank you for your prompt and helpful response, it is greatly appreciated.I already have a plan to force traffic coming from the core routers to the individual uplinks of the VSS to minimize the impact. Thanks.
Okay, I goofed up.I tried to install 2651xm flash in a 2651 router. XM flash is 3.3 V and 2651 requires 5 V.Fortunately, I did not break my router :-)Thanx.
