Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we want to do a posture for our company, we bought premier license and AnyConnect license, our requirement is to do posture using cisco secure client and not any connect , can we do that without purchasing any additional license ? and can you ple...
HI,we have two PSN and we bought 3rd party SAN certificate to be used for Portal , under SAN certificate we configure common CN name "ise.mydomain.com" and below SAN DNS=psn1.mydomain.com (fqdn of PSN1)DNS=psn2.mydomain.com (fqdn of PSN2)DNS=sp...
Hi, one question in ISE please once device MAC address for endpoint is learned by ISE and place Work Centers - Identities- Endpoints , it will stay there permanent or it will be purge out lets say if endpoint not detected on the network for particula...
Hi,we have two PSN and we configure certificate to include spnonser.mydomain.com , and under portal setting we configure FQDN for the portal to be spnonser.mydomain.com , now if we configure A record for spnonser.mydomain.com to use primary PSN its w...
Hi, we have ISE 3.2 with two PSN and we want to have guest redundancy. we created auth policy and auth profile for 1st PSN and guest portal working perfectly, now in case PSN 1 is down we want PSN2 to handle the traffic, searching old post here for ...
sorry, its not working on both PSN itw working only if i keep portal by IP address and not name if using name like sponser.mydomin.com its not working and through certificate HSTS error. we used 3rd party SAN certificate and include each ISE PSN as ...
thx for support, would you please provide exact auth policy to use , i mean exact attribute for what you mentioned " set condition IF ISE Server = PSN1" i didn't find this condition
ok will modify region and location and test, another question please if i call from cluster A to cluster B as SIP , audio is orking very fine, but if i call from endpoint with SIP to SCCP audio sometimes not working like one way audio and we have to ...
hi and thx for reply, how can i check telogs and which logs to look for? regarding locations and regions am little confused how it can be worked betwwen clusters since region you specify region and remote region in the same cluster then create 2 DP f...
