Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to use Cisco Network Assistant to map out my network. My Gateway to my tunnels to my other sites is this 3945 that shows up as unsupported. I have a community started and the 3945 is connected directly to my 4510E When I do show cdp neigh on t...
I have over 60 hours invested in trying to figure this out.I have an ASA5505 that will not connect back to my 3825.Its "sister" running the same config (except for inside subnets, and outside ip addresses that is) connects just fine.Here is the confi...
The isp providing the wan connectivity at the remote office is providing this static ip address:IP Address: 24.24.24.24Subnet Mask: 255.255.255.255Gateway: 24.24.24.24I need to create a wan connection that I can then use ...
I am trying to determine if the output of my traceroutes signal a problem with my service providers MPLS delivery. We have been having call quality issues and I am wondering if this might be the culprit.Here are 3 seperate outputs from the same 3825 ...
I have opened a ticket with my MPLS provider and as always... wait and then they come back with "nothing on our end".We are using 3825's with serial interfaces to connect 3 offices together across their mpls. There are full T1's at all three location...
Not sure how to decode this one. Nothing has changed since initial configuration. I will call the provider again.ORD3825#sh controller serial 0/0/0:0Interface Serial0/0/0:0Hardware is GT96Kidb at 0x706AD9D8, driver data structure at 0x706B50E4wic_inf...
I have changed out the connecting cable and replaced the HWIC-T1 and I am still getting poor quality. There is still a large amount of input errors, and crc errors.ORD3825#sh int serial 0/0/0:0Serial0/0/0:0 is up, line protocol is up Hardware is GT9...
