Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
once you console into the ap what is the command 2 register the ap with a conroller? i have 2 controllers and when i install a new ap it automatic register with the 1st controller, i came across a command that allows me to enter a command with the i...
Does Cisco make a signal booster product? I need an office setup with wireless access, but i can not run ethernet cable to the office. One floor below and down the hallway i have a Cisco access point, but the signal is 2 weak 2 reach the office tha...
i just upgraded my asa5520 to verion 8.2 and my asdm to version 6.0, but now when i open asdm and click on my configuration tab i don't see anything on the page. The only tab that seems to work is the home tab i'm able to see all the charts (vpn tun...
i have a Cisco asa5505 firewall running code 7.2. I uploaded the file (sslclient-win-1.1.3.173.pkg) into the disk0 without any problems, but when i issue "svc image disk0:/sslclient-win-1.1.3.173.pkg" i get an error message saying... ERROR: Not a va...
all my remote sites have a Cisco 2801 router with a T1 wic card connected back to a Cisco 7300 router. If possible, what i would like to do is install a ISND WIC card in the 2801 routers at the remote sites for backup. My question is does Cisco mak...
If i put another AP somewhere between access point1 and the far end office, do i have to set access point2 as a bridge or repeater? What type of antennae would give me the best signal? Thanks!
Georg,If i hard-code the speed and duplex to 100 and full, what would happen to the PC if the PC is hard-code at 10 and half duplex? Would the PC still connect at 10?Thanks,James
Thanks paumercierMy CPU utilization is at 31%..............Is that a average % My users are complaining about slow reply time, do you think if I add more memory to my Cisco 4006 switch it would improve?The Cisco switch is fiber back to a Cisco 6509 ...
Thisisshanky,what if i set it to its default timeslots all 24 channels would it work?would it pick up 1-4 with speed 64? Or do i have to call my provider and get the timeslotsThanks,James