Dear communityis there a way to change the data retention time (of wireless assurance data) on Cisco DNAC, we use version 2.3.5.3 at the moment?Thanks a lot and best regardsDominic
Dear community I am somewhere, that internet access is limited and I try to setup a small WiFi for a hospital. I wanted to use a C9120 as EWC + AP and some Aironet 1832 as APs.I converted the C9120 to EWC 17.3.6 but as soon as the EWC boots up, the L...
Hi guysI am writing a script, which collects data from Cisco Spaces ("Visits reports") and enriches them with information from Cisco DNAC via API.Most of the time, the MAC addresses from Cisco Spaces can be found via API and "/dna/intent/api/v1/clien...
Hi guysI tried to find a way to get notified, as soon as our Cisco DNAC 2.3.5.3 does not receive any telemetry / assurance data from our Cisco WLCs.I asked ChatGPT and got this answer, but was not able to find the menus specified in the given answer:...
Hi everyoneI am absolutely new to Cisco Spaces, but I was able to set it up with a Cisco Spaces Connector and have imported the Network Hierarchy from Cisco DNA Center to Cisco DNA Spaces.Now I am looking for a specific use case:~7’000+ employees~17’...
Hi maogo11Somehow; I do have some Cisco Spaces reports / exports and wanted to enricht client data there, for example the VLAN ID at a given date / time for a client reported in Cisco Spaces.RegardsDominic
Hi maogo11I wanted to increase the retention time for all assurance data, because I have a python script, which will search for historical data via Cisco DNAC API and after 30 days, all assurance data is gone and my script will not be able to gather ...
Hi M.I was finally able to get it to work with EWC 17.9.4 and configure the ip address statically configured:interface GigabitEthernet0mac-address 0000.1111.2222ip address 192.168.1.10 255.255.255.0no negotiation autoThanks for the help anyway.Regard...
Very simple setup: I have a switch with a mgmt IP address in VLAN 1 and a client also in VLAN 1 on the same layer 2 domain.I can ping:client > switch mgmtswitch > clientBut I can never ping the EWC from the client or the switch and I can never ping f...
