Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,Yesterday I performed the upgrade from version 16.12.05b to 17.9.4.After upgrade and reboot, four access point turned down. When I saw the log, I got the following message:Mar 10 12:30:21: %ILPOWER-5-IEEE_DISCONNECT: Interface Gi1/0/1: PD ...
Hello team,
I have an issue with two Access Point model 9115AXI, when the Wireless Controller take the AP and start to download the software, it fail after a few hours, and the access point ended damaged, not been able to boot properly.
The WC is...
Hello Team, I'm trying to copy the "Startup Config" via CLI if possible, to an USB pendrive. The idea is to get the config file, and then copy to a secondary WC that i need to configure from scratch When I made a "dir flash:", I only get one old bac...
Hello team, We are trying to configure an Access Point 9115 as an Embedded Wireless Controller (EWC) But when we try to download the firmware for WC, we are not able to complete the download via TFTP > Firmware: C9800-AP-universalk9.17.06.01 Follow t...
Hello,It's an stack of two Switches 9300H/W CurrentSwitch# Role Mac Address Priority Version State-------------------------------------------------------------------------------------*1 Active a478.06e1.6380 15 V05 Ready2 Standby 84eb.ef1f.c400 1 V05...
Hello Team,
Thanks so much for all the suggestions!!
I managed to solve the problem in the following way:
1. I made the AP recovery, with the Bundle image2. Once the AP recovery was completed, and it boot normally, I login-in with the Cisco user3. I ...
Hello marce1000,
Thanks so much!!!
Just a quick question, this version is for "Embedded Wireless Controller", it's the same for the access point to work as dependent of the Wireless Controller?
If this is the case, thanks so much!!!
Diego
Please, if someone can provide assistance with this inconvenience, I will be very grateful, since I am with the client waiting to leave the Access Point as operational devices
Hello JPavonM,
Ok, there is the possibility to request the firmware from an external server, but from where can I download the image “17.6.1” to do it?
I verified the Cisco download page, and I was not able to find this firmware version
Diego
