Hello everyone.
I wonder if anybody knows if it is possible to use a pre-existent SSL certificate for Express Way Server and Client.
A third Party Trusted Authority issued an *.theCompanyIWorkFor.com ssl certificate. I've got all the files...
Hello,
There is an ASA 5505 8.2(5). I've been working with. There are two vlans (172.21.1.0/24 and 172.21.2.0/24), one port for each, both connected to a switch, which has been configured with the same two VLANs. No trunk ports. ASA denys packets d...
Hello.
We have a cisco 3750, ip routing enabled, service dhcp (enabled), 2 vlans: vlan1=LAN, VLAN 202=cisco Phones. I need the phones to get ip addressing with dhcp. Routing is ok, If static address is configured, two points from each vlan...
Hello Everyone:
There is an ASA 5510. interface inside, interface outside, three subinterfaces in a third physical port. There is a DHCP on the LAN connected to the inside interface.
Currently, the machines get ...
Hello to you all, I'm about to buy a new Cisco Router. I will use it for routing on route-maps basis, tracking several IP addresses. Probably I will configure BGP and OSPF too. Using the comparison tool Cisco provides on one of its w...
Hi. The problem was solve. It was the DHCP Server who is triccky. Scopes must be outside any superscope created. That way It worked.
Just want you to know that.
Thanks.
Regards.
Hello Everyone. This problem was solved. The key issue was that the scope was created into a "Superscope". In order to get it to work, the scope must be created out.
Thanks for your help. At least, the cisco device config was ok.
Regards.
Here is an excertp of the config.
I cleared things that should have nothing to do with routing and dhcp features.
...
vtp mode transparentip subnet-zeroip routingno ip dhcp relay information check!......!port-channel load-balance src-dst-ipno file v...