Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When using toll fraud prevention with 'ip address trusted list', can members of this list be reached through any vrf? Or is it only the global table?
Thanks.
I see that the DRAM requirements for the software to run the 10gb service module is 1024mb. When I read the spec sheet, it shows that the installed DRAM is either 256mb or 512mb, depending on the model.
Can this module run with only 512mb of DRAM or...
Is it possible to use a Smart Tunnel through the clientless VPN portal on a Macintosh? We use Smart Tunnel with PCs and it works well. But when I try with a Mac, there is no button for 'Start Smart Tunnel'.It just shows the application 'Firefox' is a...
We have a support provider that will only use public IP space for support. So, when using a VPN tunnel for this support, we'll need to configure NAT from public address we give the provider to the private address of the device they access.The only pu...
You might want to investigate that error you posted earlier. It's saying that the forwarding table was full for multicast routes. That's probably not an expected behavior unless you have another VDC that's using all the resources.
Did you connect your laptop to e1/47? If so, try setting the native vlan to 202 so that untagged traffic from your laptop will be placed on 202.
Or you could set up an access port on vlan 202 and test with your laptop.
Did you include a metric when you created the redistribution? Since you're using named mode, you'll need to make sure the redist metric takes into account the wide metrics.
