Guru'sI have a question regarding swapping a supervisor module on the Cisco 6509 chassis. I have a 6509 and please note, the chassis is 6509 and not 6509-E and I want to get redundancy in the hardware by installing 2 Sup720-3Bs in slot 5 & 6 as that ...

HI AllWe have a requirement whereby we need to tag the physical interface (please note: not the sub interface) of a router to a particular vlan. I am aware of how to do this on the sub interface and for what I am trying to do, I want to avoid creatin...

Hi AllI have implemented VACLs in my environment to overcome the limitation of having only 2 span ports on a 6500 series switch. I have used up the availble 2 ports for spannign traffic for some other applications.I am using VACLs specifically for ca...

Hi AllI apologize in advance if this has been asked before.I want to know if there is way to change the hostnames on my cisco devices without changing config on eacah device, saving and then deploying using ciscoworks. The bleow is what i want ..as a...

I am relatively new to ciscoworks, so if this question has been asked before I really apologize.I am running into a scenario where I see the MAC addresses of almost 95% hosts/network devices but IP addresses for only some of the devices in UT reports...