Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, can anyone tell me if CUCM 7.1.3 runs ok in VMWARE (ESX3.5) I am trying to upgrade but when it re-boots I get error of :kernel panic- not syncing: attempted to kill initthanksCliff
Hi I am trying to configure a route filter to block all calls except calls to US, UK, Ireland and Australia (I am in New Zealand).the clauses I want to use in the filter are:country code == [^1] and internationall access existsORcountry code == [...
HiI have been monitoring a client attached to a port on a 3750 using Span monitor. The client is recieving multicast stream from a server. IGMP is used to control this stream between the client and the router and the switch is doing IGMP snooping. T...
Hi can anyone help, I am trying to set up NBAR to prioritize Citrix traffic using the ICA tags in the Citrix frame header. But I cannot get it to work.We are using version 6 PDLM, IOS 12.3(4)T on a 7206 when we check the policy map stats there are no...
Thanks Michael, would be nice if that bit of code put up a message saying that, I spent a lot of time trying to shoe horn this on an inappropriate version!regardsCliff
thanks guys for your responses, i have now intalled 7.1.3 on vmware, my findings below:-first of all i was actually trying to install it on esx 3.0 appologies-7.1.2 bombs out in vmware if you dont configure a viable NTP server- you cant upgrade from ...
I have attached dna output, named the files like this:dnaOutput_uk_ire_aus_to_uk.xmlfirst are the clause I am using in the filter, followed by where I am making the call to.
Hi, thanks for your reply, but it doesn't explain why it works fine for just the three, like this, any ideas:country code == [^44] and internationall access existsORcountry code == [^61] and internationall access existsORcountry code == [^353...
