Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,just a question about the command:Boot system switch all.Do this command should update the boot variable on all the switches in a stack?Model :Cisco 9200-48P. TIA, MG
Hi all,I've uploaded a wrong IOS to a Cisco 9200L switch and booted from it.Now switch is unreachable. I'll going to connect trough console cable in the next days and my idea is that the switch will be in rommon mode and boot it from packages.conf to...
HI all,is there some way by CLI or by GUI to check in real time ,which the most used protocol ,as SSH,MS-UPDATE,Etc..(with bandwith usage) without enabling monitoring-->Application visibility?Is the "show wireless client summary detail ipv4 " confiab...
HI all,i'm quite new to RSPAN y sincererly didn't get it very well.Ok is for monitoring interface traffic for interface is configured,ok i configure the "sending port" and "receiving port in monitoring",but where this traffic is forwarded?Where can i...
Hi all,I need a little clarification about Cisco wireless tools.Cisco WLC is basically to configure wireless network(ap,ap groups,radius,etc),isn't it?But when I need to monitor APs,clients,RFs,channels,etc...,Cisco WLC is not really "friendly",basic...
Thanks again for the answer.. Just last doubts ... If packages.conf doesn't works and I need to use an USB flash, the IOS in the USB must be as the same as the previous in the switch or could be any compatible? Booting from USB or from packages.conf ...
Hi all,thanks for your responses.SNMP and netflow are already configured,pointing to DNA,but,anyway,in the DNA there is no the possibility to be as granular as i want,for that my question. TIA,MG
Hi Balaji,thanks for your reply:SW1#sh monitor session allSession 1---------Type : Remote Source SessionSource Ports : RX Only : Gi1/4-10,Gi2/1-16Dest RSPAN VLAN : 230 SW1#sh run int GigabitE...
