Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI'd like to confirm how traffic is handled between different UCS fabric interconnect.By reading documentation, it seems that there is no traffic between FI switches :If servers are bound to two different FI then the traffic is switched on LAN DC...
HelloI'm checking the last support milestones of ASR 1001-X platform.The EOL bulletin states last HW support steps:https://www.cisco.com/c/en/us/products/collateral/routers/asr-1000-series-aggregation-services-routers/asr1001-x-1002-x-eol.htmlThe mos...
HiI was looking for an updated and reliable reference about what 5Ghz channels are usable for outdoor deployment in France or at least in Europe.I'm not talking about mesh infrastructure but about an enterprise deployment.I had a lot of readings and ...
HiQuestion about QOS on ASR1K series.It supports only egress queuing. So service policies dealing with shaping are usable only on output.In a design with asymetric bandwidth between interfaces (1Gbits to 10Gbits or 10Gbits to LAG 2x10Gbits for exampl...
HelloI need to export all events from level informational from an ASA5508 to a syslog server. Basically, I set it as "logging trap informational"This device provides firewall services as well as remote SSL VPN access and WebVPN.I noticed that AAA and...
As you use a single IP on Palo Alto side, I think that you may use only static NAT on ASR:ip nat inside source static 10.0.2.2 interface Dialer2Then suppress PAT on dialer2 as this static NAT will be bidirectionnal.
HelloWhat are you looking for ?I do not understand where the issue is. You device IR1833 is running IOS-XE 17.18.02.Since April 14th, the suggested release is 17.18.03:Since August 05th, IOS-XE 17.18.04 is also available but not yet suggested.Regards
HiCould you explain a bit more what do you expect ?Is it that :- all traffic from TenGigabitEthernet0/0/1.1002 to Dialer2 is PATted on its dynamic IP ?- trafic from 10.0.2.2:443 to Dialer2 is natted from Dialer:443 ?If you suppress the static source ...
I'm a novice in UCS world.If I'm right, one IOM is connected only on one FI (no cross connection to FI).So what about vNics ? As server is dual homed using two IOM on two differents FI, are vNic mapped virtually to both IOM using load balancing or fa...
HiIt is an old topic but I'm searching for reliable information about VSS reloading options.Depending of documentation and your answer for example, I don't find the same options.I had differents readings:- C6500 VSS sup-6t : https://www.cisco.com/c/e...
