Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody, Can anybody tell me what happens if WFQ runs out of queues on an interface? Let's say you have 64 queues setup on an interface and there are 100 flows? How does WFQ deal with this?ThanksMike
Hi everybody, I'm working on a VPN hub-to-spoke design with 100s of spokes. Some of the sites will be very remote and it is not always possible in some countries to get an internet connection with a static IP address.Please correct my ass...
Hi everybody, Can anybody help me out here please? I'm using the ACS appliance running software v3.3. I'm doing TACACS+ authentication from a router to the ACS box with backend authentication to a Novell NDS server. OK, I set it all up and got it a...
Hi, Does anyone know of a way to send a set of commands to hundreds of routers. My understanding is that ciscoworks can only send one command at a time.Also, does anybody know of a good way of comparing configurations across a network to a standard t...
Hi, I saw your post while searching for the answer to a different problem. I'll just reply quickly as I'm flat out.You should run 12.2.50 or later on your switch as there is all kinds of 802.1x features added and bugs fixed in that release. I run...
You can disable the floating toolbar. I finally got this working so thought I would share with you how to do this.You can use APCF (Application Profile Customization Framework) to do this. It is documented (somewhat) here: http://www.cisco.com/en/US/...
Hi Vance, I just went through this on our ASA. I had the some problem finding documentation, basically I couldn't find anything other than the config guide.We are using ASA v8 by the way. Actually. it turned out to be very simple.First you ...
Thanks for the reply but my problem is to do with Authentication, not accounting. I'm not using accounting or authorization. My problem is that the settings created for dynamic user accounts are incorrectly set to use a seperate password \for enable ...
