Hello,I will be doing small PoC to customer for manual Macsec between 2 switches. I have Cisco 3650 switches with the below image .cat3k_caa-base.SPA.03.07.02E Macsec supports on this imagebelow is the configuration on two switchesSW1interface Gigabi...
Hi,We have two 6509-E with VS-S720-10-3C but not in a virtualize environment.One of the core suddenly goes offline and couldnt able to boot from rommon.( this is the input i got from the resident engineer as the site is in remote)I might be traveling...
Hi, I hope you all are doing well.Actually i am very new to UCS & currently studying different options of UCS.I just recently got one BoQ to work on it.Problem is that i am not able to configure the attached BoQ on CCW & it can't configure on Dynamic...
Hi,I installed Cisco works LMS 4.0 recently without any prior training.Just went thru deployment guide & followed the steps.Almost all the features are configured but customer need a User tracking with IP Address & User name.I configured some of the ...
We deplyed FWSM around 3 months ago.We are still in a process of transferring our servers VLANs from MSFC to FWSM.Just yesterday I saw very unusual log in fwsm. I hope i can explain to you.We have one Zone inside the FWSM which is for Symentac Server...
Just for your information guys, SUP-8E is supported on Chassis "WS-C4507R-E"It was in the road map from cisco and now it is supported.Just issue the "Show Inventory" command and see the Chassis VID.If it is 2.0 or higher then SUP-8E is supported you ...
I think you are right but it can be only confirm by TAC.I already posted the output in this blog.Once we renew the smart net then will send to cisco.Good for us that we have redundant core otherwise it will be disaster situaltion
Yesterday, i visited the site and foun out that there is crash info and unfortunately we dont have smart net covered of one the core.Below is the error i got when i tried to boot it up with different IOSwe will be covering this core under smart net b...
