Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
switch#show auto qosAutoQoS not enabled on any interfaceThat means this config is inconsequential and not used, correct?!class-map match-all AutoQos-4.0-Scavenger-Classifymatch access-group name AutoQos-4.0-ACL-Scavengerclass-map match-all AutoQos-4....
First I'll state i also have an open case with Vmware. I inherited a vPC pair that had a number of vPC set up, but the multiple links to the VxRail host nodes were trunk links. We lost the secondary so only the trunks to the primary vPC were up. A...
Can a 10Gig SFP be used in place of 25gig SFP on a 9407 Supe2?The old switch's uplink from the core currently is 2 10Gig SFP modules.The 10Gig SFP is accepted by the switch, the core at the other end is staying 10Gig, so I'm hoping the 25GigE ports w...
Little bit different of a question. I'm going to be swapping out the floor closet switches where all the users are connected.Never fun and generally I just brute force it, config side it good so not terribly worried on that front, but I thought i'd ...
Is the command:no system default switchportthe same as:no system default switchport shutdownThe first one exists on one of my switches, but when i look it up online i only see references to the second one....
Thanks and sorry about the delay, holiday. It is multi vendor integration. And latest Dell/EMC VxRail code states they fully support vPC from Cisco Nexus devices...I was hoping someone with that specific setup would respond with their experiences. ...
I'll look through the link. Yes the VMware side is ESXi hosts, vSphere/vCenter setup and dvSwitches on that end.To be clear, the failure happened with the VxRail ESXi hosts connected to each pair of switches with TRUNK links. My contention is these...
Yup grabbing the tables I consider as part of the config side and due diligence...I should have mentioned there's no room whatsoever so yeah, old switch is coming out, cables all need to be unplugged to get the new switch in then all the cables back ...
