I am trying to configure the new ACS device, but I have challenge to make command set work. Shell profile works fine. Tacacs protocol is used. Could someone shed some light or provide a example, many thanks
I made some change (ACL) via command line yesterday, and after that I was unable to use PDM to manage the PIX even the config was fallbacked to the day before. The PDM always in the status of "loading PIX Device Manager. Please wait..." Is there any ...
Hi,After the network migration, we have experienced a significant slowdown of internet traffic. I want to some general steps to see what cause this issue. Could anyone help? I tried to find the old topics but no luck.Thank you!
Our management network is via VRF, the ip addess of the ACS also exists in the VRF. After the configuration, the ACS seems doesnt work and there is no reports on the ACS. Below is the configuration. Your help is appreciated!client: int vlan 10 ip...
I am puaaed about shell and enable and the acordingly configuration on the client. 1)If I check shell under user group on ACS, I configured aaa authorization exec default group tacacs+ local aaa authorization commands 15 default group tacacs+ local2)...
A Hierarchical LAN network design may be need to consider. Two 4500/6500 or Stackwise3750 can be used as your distribute layer SW and provide the redundancy (100M or 1000M FX/TX Port), 3560/2960/500 can be your access layer SW with connection to the ...
Thanks AK and Rick! This is really big help for me. I have been struggling on this for a while.Another question is when I use the following commands1)aaa authentication banner rrr2)aaa authentication user-prompt rrr3)aaa authentication password-promp...
1)Following the configuration for ppp authentication on dial-in router. this is through radius serveraaa new-modelaaa authentication login default localaaa authentication ppp qwe group radiusaaa authorization network qwe start-stop group radius inter...
when I try this command, there is only default available. another question is, if I use the following commands, aaa authentication login default group tacacs+ localaaa authentication enable default group tacacs+ localwhat exactly 'default' will works...
