Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. Currently I am using Anyconnect application for ChromeOS (https://chrome.google.com/webstore/detail/cisco-anyconnect/jacdijibdjifphcecdielmekkmfdpgee?utm_source=chrome-app-launcher-search) on a Chromebook device. However I can see that its latest...
Hello.I have two 7609-S boxes equipped with ESM20G cards and WS-X6748-GE-TX cards. A trunk is configured on ports of WS cards between these devices. A very important system is to be connected with two optical links to both devices via ES20 cards for ...
Hello.Tell me please if "Enhanced packet marking" feature is supported on 12000 and 7609-S series routers. Both of my boxes don't seem to support "table-map" command. Feature Navigator doesn't display these platforms under "Platform" list either.Than...
Hello.Could anyone provide me with a link to documentation, describing how a default queue limit for a particular class is calculated on a ES20-GE3C linecard.The same policy map applied to interfaces with configured BWs of 1 Gbit/s and 4 Mbit/s produ...
Hello!Could anyone please give me some links to the documentation regarding hardware requirements for running VPLS. I have been searching through cisco.com for two days but failed to find anything significant. Only managed to get some clues that 7600...
Hi. I have an experience of using Anyconnect on a Pixelbook. DNS name resolution turned out to be quite tricky and I would divide it into three parts:1. ChromeOS itself uses DNS servers provided by Anyconnect and resolves names properly.2. Linux appl...
Hi.I did not try to configure service instance on port-channel interface but comparing to single GE interface configuration it seems that you forgot to add "rewrite ingress tag pop 1 symmetric" command under ethernet service instance configuration. T...
Hi.No, it is not about QPPB.I refer to a table-map for automatically mapping mpls exp to qos-group for example. I actually only need the commands "set qos-group mpls experimental imposition" and vice versa "set mpls experimental imposition qos-group"...
