Member since ‎09-02-2015

User Statistics

  • 152 Posts
  • 0 Solutions
  • 35 Helpful votes Given
  • 35 Helpful votes Received
Recent Badges
 30 Helpful Vote
1 Accepted Solution
10 Helpful Vote
50 Replies
1 Helpful Vote
20 Replies
10 Replies
5 Replies

User Activity

we have four blades that we want to add vHBA adapters. The blades are currently associated to service profiles. withing these service profiles i can see a reference to a single vNIC/vHBA placement policy. <<<---- How do  i edit this placement policy ...
we are trying to connect some B200 blades to a fiber channel storage array. the blades are running vmware esxi when i go to look at the storage adapters i do not see any HBA for fiber channel. Do i need to create virtual FC HBA? How do i do this? I c...
Hello, I'm looking for some assistance with the following. connecting a pair of 6324 FI's to upstream fiber channel switch    Is there any guides available for this I could not locate anything >
hi we have a single switche on side A and a pair of nexus switch's on Side B  we are adding a second switch to side A. we already had VRRP enabled on Side B looking to make side A redundant  see diagram  my question : can i use thee same port-channel...
hello we have just booted up a cisco Aironet 3802I (AIR-AP3802I-A-K9) access point. i've connected using SSH and logged in.  there is no copy run start cli command from what i can tell? What am I missing here? (feeling very stupid)  cisco AIR-AP3802I...
Community Statistics
Member Since ‎09-02-2015 02:02 PM
Date Last Visited ‎03-03-2023 12:43 AM
Posts 152
Total Helpful Votes Received 35
Helpful Votes From
Helpful Votes Given To