Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I suppose this is rather a simple question but I not sure on the answer I have in mind.
Please take a look a the diagram as this explains for 99 % the situation :
As you see at the left side a 100 % simple LAN.
At the right side a single...
Dear,
Went already looking in Cisco documentation and even CCW Estimates but can't find how to quote ( or the needed part codes for) this migration.
10 users are needed, CUCM v11
What top level part code should I use in my estimate ?
Kind regards....
Hello,I suppose you only need to register this switch within the/yours 'end customer smart account'.It has been sold as 'LAN base' so the system should recognize it that way ( based on serial id's ).RTU licensing isn't managed in SA'sKind regards
Hello Deepak, thanks for our ( very fast ) answer.
I fully understand the config.
Just to be sure : clients will need to browse to http(s)://10.0.0.254/ to get to the server ?
And the server will communicate back to 192.168.100.254 ?
Found it : MIGE-UWL-11X-STD
in http://www.cisco.com/c/en/us/products/collateral/unified-communications/unified-communications-licensing/guide-c07-735914.pdf
