Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,I have been reading through the design documentation for the Wireless devices, and I can't seem to find a definitive answer to the following:Is it possible to have a centralised WLC (in a DMZ) which controls many remote sites? Each site sh...
Hi Folks,We have a multi-context ASA setup on our network. Without going into too much detail, one of the contexts is used specifically for primary / secondary school access.We have recently migrated all our schools to a new IP address scheme. Howe...
Hi Folks,Please could somebody confirm if the 2801 router is capable of communication with Call Manager via H323.I was just about to order the equipment for a deployment, until I came accross the following document:http://www.cisco.com/en/US/docs/voi...
Hi folks,I have just established a RDP connection accross the internet between two pc's both running between ADSL connections.When the connection is made, the firewall on the remote PC reports a connection from the NAT'd address of the local pc. How...
Hi,I am having trouble establishing multiple simultaneous Meet-Me sessions.I have one CFB (Software) setup - which is globally accessible. As stated I can establish one "Meet-Me" conference, when other "Meet-Me" conferences are sttempted, they recie...
Hi, I also have the same issue. We are running an ASA 5520 7.2(4) in multiple context mode. I cannot enter the "sla monitor" command, as it is not recognised.The only reference I can find regarding SLA monitor setup, is concerning the ASA 8.0 code....
Hi Brandon, thanks for your reply.The "Maximum MeetMe Conference Unicast" is set to 10 on both the subscriber / publisher.The partition of the CFB and DN's are all accessible.
