Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I get e-mail alerts daily about MGCP gateways decreasing or increasing and also MGCP D-channels going out of service. When I look at the alert detail in RTMT it shows me what gateway is having an issue, but the e-mails don't specify anything but the ...
I have a BYOD account with Broadvoice set up and I was wondering if anyone has been successful in setting up a SIP trunk with Broadvoice? Technically, it's not supported by Broadvoice but.... I talked to a couple of techs over there that said it shou...
Hello. I'm trying to connect my 7971 with a SIP image to the third party Broadvoice service. My SIP load is SIP70.8-3-3SR2S. I talked to tech support at Broadvoice and they said that the only way I can get a 7971 to work with them is if I hardcode th...
Is it possible to to anything other than E&M on a T1 CAS port plugged into a 3845 MGCP gateway? CCM is 4.2(3). I need to talk to a legacy IVR via loop-start. The only option I'm given on the CCM gateway config page is E&M.Regards,Jason
Hello - I have CCM 4.2(3) and a 3845 MGCP gateway. Between the gateway and my legacy IVR (Edify Workforce) I have a T1-CAS circuit. I can successfully place a call into my IVR. My IVR has a script that allows me to input an extension and be transferr...
Thanks for your input!!! I'm not trying to change the alert detail. I just want it to send the full details to my e-mail distribution. Right now it doesn't send everything, The alert detail in RTMT tells me what gateway went down but the e-mail alert...
Thanks. So if I can only do loop-start with T1-CAS when using H323 then how can I use the hookflash feature? As far as I can tell hookflash is not supposrted on T1-CAS while using H323.Thanks,Jason
Me too. I'm trying to integrate CCM 4.1.3 and a 3845 via T1 CAS to an Intervoice/Edify. I set up a route pattern for 36XX to point out the CAS trunk. All I get is a slow busy. Any advice? I tried both MGCP and H323. I'm sending all digits to the Edif...
