Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all. I have to replace some older model VoIP phones such as Model# 7975 with newer model phones such as Model# CP-8851NR. The current way that I am doing it is by adding the new mac address to CUCM under model 8851NR. I then have 2 windows o...
Hello all, I am having issues with wireless controller Catalyst model 9800 L-F and access point model AIR-CAP3702i-A-K9. I have 2 of these access points and only one of them is able to join the WLC. The one giving me issues has a solid green light ...
Hello I am trying to update the IOS with file asr1002x-universalk9.16.03.10.SPA.bin. I copied it from a usb drive to the dir flash: I am not sure on the commands to install the firmware. I don't care for the configuration on the router, just need i...
Hello, I am trying to figure out how to create a guest wifi SSID with limited privileges. I also need it to have a splash page, kind of like when you go into a Starbucks to connect to their wifi and you need to accept their terms and conditions befor...
Hello I am having an issue with a wireless controller Catalyst model 9800 L-F and access point model C9115AXI-B. The APs are able to join the WLC but after 2 minutes or so, they will drop, start blinking green, red, and off and then rejoin the WLC. ...
I had the settings you have below minus the virtual ipv6. I don't have a public certificate assigned to WLC or a trustpoint set up in webauth global. Just need for users to access the wifi on site with Chrome and login to splash page with guest user ...
Is there a way to force the client device to open a browser to navigate straight to the splash page virtual ip address 192.0.2.1? If I am on a laptop connecting to the guest wifi, I almost always have to input a random website address such as cisco.c...
It is currently on 15.2(4)JB. I downloaded the image filename: ap3g2-k9w8-tar.153-3.JPN.tar and I was able to run the commandap: tar -xtract tftp://x.x.x.x/ap3g2-k9w8-tar.153-3.JPN.tar flash:I tried to boot after this but it booted the old one. I the...
