Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have 2 Cisco C9300-48T in Stack (Physical Stack), Right now we have "C9300-48 Network Essentials" license installed, but we need to have BGP Functions and because of that we purchased 2x"C9300 Network Advantage" Licenses. Also we have runni...
Hello,We have several cisco IP phones 7965 which are working on SCCP Protocol, we would like to change firmware to SIP. I tired to do like Sreekanth Narayanan told in this discussion https://community.cisco.com/t5/ip-telephony-and-phones/change-from-...
Hello,We have 3 old cisco WS-C3750X-24S-E - in stack, also in every switch we have inserted C3KX-NM-10G module.This C3KX-NM-10G module has G1, G2/Te1, G3, G4/Te2 Ports. I have inserted 10G sfp to the G2/Te1, G4/Te2 ports in the first switch module an...
Hello,We have cisco Router C1111-4PLTEEA with c1100-universalk9.16.12.04.SPA.bin installed firmware. Also we have Site2Site VPN with our HQ. CCTV traffic from this router is going to HQ via vpn, but during this process we have a lot of packet loss is...
HelloWe have Cisco 1140 with FDM Management, version is 7.2.5. How do I need to configure DHCP Relay? Because I did all configuration, but int not working
Hello, thanks for your reply,Then I will do firmware upgrade up to 17.15.3, then reboot, after that I will do license change and then one more reboot, correct? Also do I need to somehow prepare license on cisco smart license portal itself?
I think I need to somehow activate this purchased license on Cisco portal? and then do "license boot-level network-advantage addon dna-advantage" command on switch itself?
Hello, Thanks for your replies,Then I need to do License change - which not cause reboot, and then I just need to to upgrade up to 17.15.3? Several month ago we did firmware upgrade for Cisco 2960X up to recommended version and it made switch unfunct...
