Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey there,I've pasted the output from a router interface that has a policy map prioritizing VOIP and signalling. I am puzzled why I see no packets/bytes matched when my offered rate is at 14000 bps. See below,FastEthernet0/0 Service-policy output: ...
We have three 6509's basically connected in a chain. The first two 6509's share the responsibility of being the root bridges for all the VLAN's. The first two also run HSRP. Switch 1 is primary root for odd numbered VLAN's and secondary for even's...
My company had an incident recently. A 'user' installed a WAP at a remote area on a flat portion of our network. The WAP's DHCP server started handing out 192.168 IP's. This caused a great deal of chaos. Problem detection was compounded by the fac...
I have been tasked with securing a SCADA LAN with many devices/app's that need to talk outside of this subnet. I thought that an easy way to build the ACL would be to use an ACL like "permit ip any any log" and then slowly add the lines as they appe...
I have 55 routers connected into an ATM/radio network. I am running EIGRP. This network basically acts a bridge. All Router WAN ports are on the same subnet. There are 6 main locations on this network with up to a dozen of my routers hanging off ...
Thanks a lot for the information guys. This router port is connected to an Alvarion AP-10 radio that has 2 meg of bandwidth configured on it. Unfortunately, the radio has about a 200 to 300 pps limitation. From what i've seen, it is probably close...
Thanks for the replies guys. The TAC said the reason that the port numbers weren't showing up was because I did not have any port numbers in the same statement as the log. Putting in just one port number, even if it is a port you will never use, ac...
Thanks Ahbanks. The routers are actually ethernet connected. I went ahead and removed eigrp from all of them except the gateway. I added static routes on the gateway to about 60 LAN subnets that are on this network. I then got the carrier to remo...
