Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am running into this very weird problem. Under Policy -> Profiling -> Profiling Policies, there are list of 300+ pre-define Cisco policies for all kind of devices. We have created our own policies for the devices that we use and also few actually d...
Good Morning Everyone,
I am looking for some help on how to create a Read-only user on ACS so we can used it in Cisco devices. I can't find anything on how to create Read-only user for UCS and cisco switches. I was able to creat user and try diffre...
Good Morning Team,
I was hoping someone might have done this in the past or at least guide me in the right direction. I am trying to deploy 2FA(CAC, smart card) portal access for out Cisco ISE 2.4 but running into few problems.
I am currently c...
Good Morning Everyone,
I was hoping someone could help me out with Cisco ISE 2.4 installation on our C220 server. We had a Cisco ACS installed on the server for years and now we switching to ISE. I was able to upgrade CICM and Bios to 4.0.1 version...
Good Morning,
I'm sort of a new when it comes to Prime, worked a lot with SolarWinds for the last 4 years. I have configured NetFlow on my 6509 and we are getting good statistics on the switch:
Flow Exporter HQprime:
Packet send statistics (last cl...
Thank you guys for the assistance. The original error was actually from UEFI boot and it coudn't see the drives. I was able to roll-back BIOS and CICM to 2.0 and install 3.0.3(a) and the installation was able to finish without any problems. I've conf...
Hi,
@hslai wrote:
... I've started installing ISE over and VKVM and boot it up from the ISO image. I took over 2hr to go thru installation points 1/515 and so on. After that was done, server rebooted but once it booted UP it went back to Linux Comma...
Thx Mark for all your help. I have verified that 9991 is the correct port and I can communicate with that switch over SNMP so I don't think is a switch problem. I will hit up those guys.
Thx again,
You were right. That 7/1 was a L2 interface so I have applied that IP FLOW on the VLAN interface and it took these commnads without any problems. Now i have another problem. I cant see that device under DATA STORE which should come automaticly. I can...
