Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone used a transparent TCP Proxy solution as a performance enhancement tool (via caching or buffering)?Does Cisco has anything? WAAS looks the closest but it more like a point to point solution (wan acceleration). I am looking after something ...
I have the same scemario as in the example mentioned by the link below, but it doesnt work. I have opend a case with Cisco, got to tier 3 with no resolution ...I basically need to access from inside my DMZ servers on both the public and the dmz IPs. ...
I have a 2801 router with a 4 port POE switch card. I have a PC plugged into one of the switch ports.For some reason every 1 or 2 min I stop seeing the MAC in the mac-address-table (it is still in the arp cache though).If I start pinging it again I l...
I have a cisco switch 3560 w PoEI have configured the ports for IP phones.I have plugged the Nortel i2004 phones into the ports but ... no powerThe port shows is err-disable state.If I disconnect the IP phone, do a sh-no sh then the port shows UP UP ...
Thank you.This is what I have experienced as well.The thing is that on the PIX 6.3.5 I am able to hit both the public and the dmz IPs at the same time (alias command).When we "upgraded" to the asa 7.x, the alias command stopped working and we ended u...
Well, I have tried destination NAT and it didnt work, then I have tried DNS doctoring, same.And then I have tried both, no luck.My config is similar to what the example shows (just the IPs are different). As for the destination NAT I have tried mult...
I implemented WPA with PEAP (352cards, AP1100, CSACS1111) on XP SP1&supplicant.Works fine (so far).I wanted to put SP2. Now I will have to be more careful...C
