Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,thank you to help on some clarification about off site protection and what kind of interaction does it exist between remote clients and local AD for umbrella reports and authentication.we need to validate one feature , if they are feasible...
Hello We have a customer, having one single site with one virtual wireless controller installed on a VM and 200 acesss points located in the Same site and connected to a single vlan ( Vlan 60 ).the customer is facing multiple performance problems whe...
Hello Gents,we need to configure 802.1x feature on a truck port ( 802.1q) of a catalyst switch , does this work without any trouble with the two features on the same port. this scenario is required because we have a third party access point with 802....
Hi All
We need assistance about the Cisco Vwlc ( virtual wifi controller ) password recovery procedure , we have an already installed Cisco virtual controllr on vmware ESXi , for which we need to do password recovery , if you have any documented pro...
Hi alI ,I have a customer that already has 1121G Ap autonomous deployed, I will convert them to Lightwight ones and install a 4402 controller and will add other 1041N ap THAT will be controlled by the controller in teh same time.Does any one tested...
Thank you for your reply , I will apply these recommandations and let you know next week , because I need to travel in the ustomer site.in the meanwhile please can you help me to clarify some ideas from design purpose :1- since the vwlc supports onl...
We have only one ssid and one clan for the WiFi , we have about 1500 to 2000 clients , the frequency used is the same 2,4 GHz for all the AP which are composed for 195 AP 1041n and 5 AP 702the performance problème is not observed on the PC connected ...
Thank you for your replies,1-the access points are a mixture between 1041 and 702.2- thé L’an design is the following :two central 3850 12S layer 3 switches Wich are connected to the cabinets on the different floors via fiber optic 1Giga link , each...
Thank you for your reply , I will try that I let you know.We think about this methodology as an escape because we have behind an ubiquity switch and I have searched for the ubiquity radius disctionary , there is no informations on it and the few inf...
Thank you for your reply , since we have a third party access point connected to the port of the switch ( ubiquity unify ) and not a cisco AP what is your recommandation for doing web redirection to our ise hotspot for the clients connected from th...
