Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello We have a customer, having one single site with one virtual wireless controller installed on a VM and 200 acesss points located in the Same site and connected to a single vlan ( Vlan 60 ).the customer is facing multiple performance problems whe...
Hello Gents,we need to configure 802.1x feature on a truck port ( 802.1q) of a catalyst switch , does this work without any trouble with the two features on the same port. this scenario is required because we have a third party access point with 802....
Hi All
We need assistance about the Cisco Vwlc ( virtual wifi controller ) password recovery procedure , we have an already installed Cisco virtual controllr on vmware ESXi , for which we need to do password recovery , if you have any documented pro...
Hi alI ,I have a customer that already has 1121G Ap autonomous deployed, I will convert them to Lightwight ones and install a 4402 controller and will add other 1041N ap THAT will be controlled by the controller in teh same time.Does any one tested...
Hello,I have got to establish a SIP trunk between ccm6.0.1 and some Patton SN4960. My problem is my trunk is functionning in a single direction. Meaning when i call an ip phone registred with the patton gateway it works fine but when ip phone registr...
Thank you for your reply , I will apply these recommandations and let you know next week , because I need to travel in the ustomer site.in the meanwhile please can you help me to clarify some ideas from design purpose :1- since the vwlc supports onl...
We have only one ssid and one clan for the WiFi , we have about 1500 to 2000 clients , the frequency used is the same 2,4 GHz for all the AP which are composed for 195 AP 1041n and 5 AP 702the performance problème is not observed on the PC connected ...
Thank you for your replies,1-the access points are a mixture between 1041 and 702.2- thé L’an design is the following :two central 3850 12S layer 3 switches Wich are connected to the cabinets on the different floors via fiber optic 1Giga link , each...
Thank you for your reply , I will try that I let you know.We think about this methodology as an escape because we have behind an ubiquity switch and I have searched for the ubiquity radius disctionary , there is no informations on it and the few inf...
Thank you for your reply , since we have a third party access point connected to the port of the switch ( ubiquity unify ) and not a cisco AP what is your recommandation for doing web redirection to our ise hotspot for the clients connected from th...
