Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have Cisco 8841 model phones, which currently have SIP firmware installed. Now, I want to upgrade all of them to MPP/3PCC firmware.However, when I try to do this via Tftpd64, which used to work before, I am now unable to upgrade the firmware....
Hello everyone,I have configured my Cisco 3700 Series Autonomous Access Points. Now, I am looking to configure the Antenna Gain setting, and I noticed that the command line allows a range that includes -128. Is setting the Antenna Gain to -128 a corr...
Dear all, I would appreciate your guidance on setting up my network.I am using Cisco 3700 Series Access Points (APs) across a 5-story building, with APs installed on every floor. I am currently enabling both 2.4 GHz and 5 GHz bands. The 5 GHz band wi...
I am using a Cisco router as a Call Manager, and I’ve encountered a problem that I can't seem to find a solution for. Most of the phones have an issue where they disconnect shortly after a call starts, whether it’s an incoming call or a transfer to a...
Hello,For loop monitoring, please recommend a suitable tool or command to detect a loop. Specifically:How can I detect a loop on a Cisco router?How can I detect a loop on a Layer 2 switch?As I am currently facing a serious issue, there is a loop in m...
Previously, an engineer had set the Antenna Gain to -128 across all the access points. Why did he do that, and what was the benefit of setting it to this value?
Thank you for the reply.I'm using (AIR-CAP3702I-A-K9) Autonomous.And I want to learn one thing: how to set the Transmitter Power (dBm) from 2.4 GHz to 5 GHz?Because we are using almost 60 APs on our 5 Floors.
