Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've got a vendor that has several Bosch alarm panels that in the past have been using POTS lines. We've been trying to move away from POTS lines where possible & have a DID block from 4400-4599. I created a DID as a replacement for the old POTS li...
Hello, I've got a C8200-1N-4T that I've been having some issues adding to an instance of Cisco Prime 3.10. I've confirmed that the SNMP v2 community strings are correct for Read/Write access & that the SSH v2 credentials are correct as well. I can SS...
I've found 4 switchports on two switches in our environment that are automatically reverting changes that are made to them. In this case, I'm attempting to simply change the assigned VLAN of the switchport and then bounce the port. When I look at th...
I've got the WLC added via SNMP without any issues, but for some reason, the AP's are not populating. The AP's are a mix of 9176, 2802, & 3802's. The VLAN has been discovered in Prime, Not sure what is missing or what might be causing the AP's to n...
We've discovered that multiple analog copper POTS lines that we have (Primarily for FAX), have stopped being able to send out, but can receive faxes fine. During the troubleshooting, a colleague & I have found the following. In the somewhat recent pa...
Yes, up until a week ago, these had just been straight analog connected to a POTS line. Path was as follows:Previous Path: Copper (POTS) Provider > 66 Block > Alarm PanelCurrent Path: VG410 FXS Port 0/1/1 > 66 Block > Alarm Panel
Thanks & yes, I am referring to a Direct Inward Dial by DID. We have two phone providers currently, Frontier for POTS/Copper & Spectrum for SIP, which the DID's reside under. The DID in question ends in 4486. I have uploaded a sanitized config of the...
Thanks for the tips, I did attach a clean copy of the config for you to review when you have a moment. I did find the 924 template, but that tempate wasn't applied at the interface, so I'm not sure what else might be causing it?Also, I enabled the lo...
1) do you have some function like smartport macro's enabled ? > No, nothing of that nature was ever configured. the switch might dynamically detect an access point is connected and apply corresponding macro?2) do you have a authentication-server (rad...
