Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey there,
I'm curious if the WLC9800 supports more than 8000 APs or if there's another solution available. Can you provide some insight on this?
Thanks!
Hello there, could someone help me with an issue I'm experiencing with the Cisco C9500 switch? Following a recent complaint, I investigated and discovered that the switch stack is currently in ROMMON mode. I attempted to boot from a USB flash drive c...
Hi,We have WLC 9800 with different APs connected to him, last night we upgraded it from 17.3.5 to 17.3.6 for some compatibility reasons with 9130axi to add some new APs, so far everything was good, but after the upgrade, several access points from t...
Hi Guys,I hope someone can help me with my problem, I need to downgrade my WLC9800 and my AP 9130 at the same time, I tried to downgrade it, but it seems to only downgrade the controller, the AP keeps the same version, and can't join the controller b...
The C9130AXI-E APs were initially manufactured with Version V03, which is not supported by our current version ofour WLC (17.3.5b), so they won't be able to join the controller unless we upgrade to 17.3.6.The link below explains the problem; perhaps ...
Hi Balaji,I just found that the image I used 17.3.5 not supported by the Access Point, I will try the image that is supported then we will see if she will accept it.
