Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a very strange problem, I hope someone can offer insight. I have a cisco 3845 w/IOS ver ipbase-12.4(2)XA which is directly connected to my ISP. Behind the router I have a vpn concentrator. I am having a problem passing ESP traffic over es...
Hi All, I am currently studying for the CCSP, I have taken 3/5 exams and have CSIDS and SAFE to complete. I am working on the CSIDS and would like to be able to work with the command line. I would like to purchase or rent a unit for little money (if ...
Hi All,I am currently studying for the CCSP, I have taken 3/5 exams and have CSIDS and SAFE to complete. I am working on the CSIDS and would like to be able to work with the command line. I would like to purchase or rent a unit for little money (if t...
I am having a problem with multicasting on 2 3750 switches, here is the Topology: 2 cisco 7200 routers configured with hsrp connected to 2 3750's running hrsp (The router interfaces are connected to vlan 202). I have another vlan configured (vlan 63)...
The flow will be the same whether it's an L3 or L2 port, all traffic will be compared against the FIB and checked for adjacencies...if an adjacency exists the packet will be hardware switched to the destination otherwise it is sent to the L3 routing ...
The config is the same for both switches:(this will enable port channel bundle, you can specify upto 16 ports..i would recommend 10)(config-if#)interface range gigabitethernet 1/1-2(config-if#)Description PORT-CHANNEL Interface(config-if#)switchport(...
Hey shalabh,I would firt make sure my supervisor redundancy is set for SRM SSO, this will provide the fastest failover in the event that a sup engine fails. Do you want the 6513 to handle loadbalancing for servers? if so, you'll need to purchase addi...
VTP is independent of trunk encapsulation. It should work fine.I would definitely recommend keeping a standard trunk encapsulation. dot1q is always preferrable since its and open standard.
