About hs08

hs08 · 10-07-2026

I use fortinac and sometime i got complain from user that they can't access to the network, then i can see in the event viewer there are log And from the switch (Cat 9200L) i got this error Oct 8 10:37:18: %DOT1X-5-FAIL: Switch 1 R0/0: sessmgrd: Au...

hs08 · 09-10-2026

In my WLC 2504 i have several interface such as interface for IT, HR and Finance then why I can't access the gui and ssh if I access from those subnet even i use wired connection (ping is reply)? If i access beside those vlan then i can access both t...

hs08 · 09-01-2026

I was success integrated C9200 to Fortinac, but from yesterday i facing some random users is loss access / move to isolation network with below message in the log. I check from fortinac and the nac send access accept, also if i unplug and plug the la...

hs08 · 08-28-2026

I was successfull create SSID with 802.1x on WLC 9800 with WPA2 and 802.1x as shown in below picture But i create same thing on WLC 2504 then when endpoint try connect to this SSID there is no option connect using certificate? I only prompting usern...

hs08 · 08-27-2026

I successfull create dynamic vlan on WLC 9800, but it's not work for WLC 2504. Should i create dynamic interface group on WLC 2504 for dynamic vlan?

hs08 · 09-10-2026

there is no acl between my endpoint and the wlc, also ping is reply.

hs08 · 09-10-2026

Hi @aleabrahao , here the output Interface Name................................... management MAC Address...................................... 50:f7:22:0e:8d:0f IP Address....................................... 10.7.102.2 IP Netmask....................

hs08 · 09-10-2026

Hi @aleabrahao Let say wlc mgmt ip address is 10.7.102.2, IT is 10.7.3.2, HR is 10.7.19.2 and Finance is 10.7.11.2. What i mean is if i access to http://10.7.102.2 from IT, HR and Finance then i not able to access, but if i access from outside those...

hs08 · 08-29-2026

hi @Stefan Mihajlov @ammahend @aleabrahao I use same endpoint and the certificate already installed in the endpoint. When the endpoint connect to the SSID on WLC9800 there are option to enter the credential or connect using certificate. Same endpoi...

hs08 · 08-28-2026

Hi @aleabrahao yes i use local switch and after read article what you share then the dynamic vlan is working. Previously i already create flexconnect group but i set on WLAN VLAN mapping and here i only can map 1 ssid with 1 VLAN.

Member Since	‎11-28-2022 05:57 AM
Date Last Visited	‎10-07-2026 10:50 PM
Posts	495
Total Helpful Votes Received	55

User Statistics

User Activity

dot1x intermittent

Can't access WLC 2504 GUI

Authorization failed or unapplied for client

WLC 2504 dot1x

WLC2504 Dynamic Vlan

Re: Can't access WLC 2504 GUI

Re: Can't access WLC 2504 GUI

Re: Can't access WLC 2504 GUI

Re: WLC 2504 dot1x

Re: WLC2504 Dynamic Vlan