Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone.I am new to the forum, and I have seen that everyone shares their knowledge and experience, so I dare to ask, thanking in advance to those who take the time to read me.I am currently trying to deploy a vMX on AWS in routing mode in the...
Hello team.
Currently I want to deploy ipv6 for some nexus 3500 devices and I have found that ipv6 is not supported for nexus 3500's (CSCwf36829 - IPv6 not supported on Nexus 3500's), however in the Bug Search Tool it only indicates it for version 9....
Good morning everyone.I am reaching out to you today for some support as I have the following situation:For some time now I have noticed that during my calls whether internal or external I hear hissing / static sounds, these sounds continue even thou...
Hello team, I have added 2 accounts for access to the SNTC portal, one is more than 15 days old and the other more than 24 hours ago, the status of the users is approved in CSAM and I have received the confirmation email, however I can not access bec...
I was granted access to SNTC and received an email from cisco. It has been more than 24 hours and I am still unable to access the portal. When I try to access the page it redirects me to the following page:
I have 2 accounts with Administrator permi...
PhilipDAth.Thank you for your support. With the addition of a new interface differentiating LAN traffic from WAN traffic, it has been useful in achieving the goal of making the vMX the internet gateway for cloud resources and the connection point to ...
Hi team, I am in the same situation as @viniciussilvagarcia. I have registered two accounts, but I have not been able to access any of them.
I hope you can support me.
Regards
The solution to my problem was to enable CDP general and on the tunnel interfaces. Because the PBR uses the CDP to be able to validate if the next hop I am pointing to is active:
route-map FILTERset ip next-hop 172.16.243.254 172.16.244.254set ip nex...
