Hello,anyone can help me find the command to use to deny any host to communicate with an other connected at the same access point?I have a 1231 Aironet AP.Thanks,Omar,
I have a Cisco 3725 with a 32MB of flash memory, to have an IOS with Advanced Security.to do this I updrade my flash to 64MB as slot0.Now I have two IOS, but the problem is how to choose the IOS:the config register is set at 0x2102the boot system com...
i have a central site that is connected to a X25 network by three links (three dialing numbers availible)also i have three remote site eachone with one lin to the same X25 network.i like to balence charge whithin the three links to the central site (...
i have the topology shown at the attached file.the site is connected to the X.25 network using 3 links of 2Mbps each.I have to use only the 1st one, if broken than the 2nd next the 3rd.. but once the first fixed it have to balence automaticly.i mean ...
Well, I'll try to format it, because in the boot process it shows me the error:Wrong magic numberand it cannot load the image from the slot0, it's I think due to the flash was formatted on a other platform. here a link to a document that expain file ...
I asked for this, and I have something to say about this..The router as it's connected to the ISP, should use a static NAT'ng, so it NATs all the traffic received from the externat segment to the PIX.The PIX uses a dynamic NAT so the internal traslat...
Hi,Well, I'll try to erase the old IOS once I have access to our client router, I didn't try to erase it before because I don't like if the router while rebooted runs the ROMMON, and I'll need to use the xmodem so I didn't have enough time to do beca...
Hi,well, you want that if you have a packet arrives from an interface you don't let it goback from the same interface, unless the routing table tells to forward it to this interface?? I think that by default, a router doen't forward packets to the sa...