Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Our 7603 has a PCMCIA 24MB Flash card in it from which the IOS is loaded (slot0:). Is it possible to remove this card while the router is up and running? Is there a procedure to effectively "dismount" the device prior to removing it, if so? Tha...
Sorry about the elementary nature of this question, but I can't seem to find an answer. I have a 7603 currently loading ROMMON from the gold region, with regions F1 and F2 marked as INVALID. My question, is if I upgrade the ROMMON version to region F...
Hello,I have a 7603 with the following message;Router#sh rom-monitor slot 1 spRegion F1: INVALIDRegion F2: INVALIDCurrently running ROMMON from S (Gold) regionCan anyone provide a link or summary of the ROMMON regions and/or the procedure for moving/...
Sorry about the elementary nature of this question. When an ACL is applied to say a VLAN's SVI in this way;interface Vlan111 ip address 10.10.10.10 255.255.255.0 ip access-group 111 in or ip access-group 112 out..does the traffic direction "in...
Hello,Does anyone have a link or reference to a good description of the Cisco 7600 boot process and various memory heirarchy functions? I'm looking for information on what should be in NVRAM, FLASH, SUP-BOOTFLASH etc. Thank you.
I have a similar situation where I'd like to boot a newer IOS image via tftp, and want to fall back to flash in the event of trouble. Problem is, I can't find any info that would tell me how to configure ROMMON to bring up an ethernet interface, and ...
When you say you're seeing only 3 SVI's, I take it you mean that there are only 3 "interface Vlan x" entries in your running/startup config?Realize that creating a VLAN does not mean that an SVI is created for it. If you used "Vlan database" or in gl...
