Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello CommunityI'm facing issue with switching between Route Groups which is prioritize in the Route List, I have 2 prioritized list of available paths (i.e. two PRI connection) in route list when the service outage occurs for the 1st path then the a...
Hi,I'm quite new to the Cisco unified communications manager. In my premises I have two PRI connection at gateway Primary PRI => 022 4303 "extension number" for Incoming calls and we need dial 90 "mobile number" for outgoing calls with reference to ...
Hi,I'm quite new to unified communication but want to write a power-shell script that will call to CISCO IP phones. I have all call manager set up. I have tested the below PS script which works well but in that case, I need to attach my mobile with m...
Hi,I'm Quite new to the unified communication, but want to write a power-shell script which will call to a CISCO IP phones. I have all call manger setup. I have tested below PS script which works well but in that case i need to attach my mobile with ...
Hi Leonardo,If you have any reference guide to register Cisco IP phone to CUCM over external network using MRA with Expressway´s or Cisco Webex Calling, please share with us, I need to configure same for one of my clients
Heartiest thanks to you sir You are correct that there is nothing related to the missing partition in CSS, The problem is in our testing method, in our setup the the SIP PRI is terminated on the Router (say Router A) - L3 core switch - Voice GW 2951 ...
Good day, Sir.I'm happy to report that all calls were terminated via MGCP yesterday whenI added a few missing partitions in the CSS-ISD and tested them by puttinga dummy destination IP in the SIP trunk configuration. I am grateful foryour assistance ...
Hello Sir,I have implemented the recommended changes in the route list level for each priority wise added RG and same is attached in the below link starting from page 12, also attaching calling party transformation pattern.Now as result when I assign...
